ADAPTIVE VARIABLE SUSPENSION SYSTEM, Diagnostic DTC:C1785
| DTC Code | DTC Name |
|---|---|
| C1785 | Steering Control ECU Communication Error |
DESCRIPTION
The absorber control ECU receives signals from the front steering control ECU via CAN communication. When there is a communication malfunction, the malfunction will be detected by the diagnosis function.
| DTC Code | Detection Condition | Trouble Area |
|---|---|---|
| C1785 | While the power switch is on (IG), the front steering control ECU malfunction signal is received for 5 seconds or more. |
|
CAUTION / NOTICE / HINT
Note
-
Before performing troubleshooting, inspect the connectors of related circuits.
-
If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first Click here.
-
Before replacing the absorber control ECU, perform all of the following again: 1) symptom simulation (See page ); 2) DTC inspection (See page ); and 3) GTS inspection (ECU Data List or Active Test Click here. If no malfunctions are found in other areas, replace the absorber control ECU.
-
When the absorber control ECU is replaced, switch to test mode and check that all test mode DTCs are cleared when their respective deletion conditions are met Click here.
PROCEDURE
-
CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
-
Check for DTCs Click here.
Result Result Proceed to CAN DTC is not output A CAN DTC is output (for LHD) B CAN DTC is output (for RHD) C
B 
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITHTROUBLESHOOTING) Click here
C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITHTROUBLESHOOTING) Click here
A 
-
-
CHECK FOR DTC (VGRS SYSTEM)
-
Check for VGRS system malfunction DTCs Click here.
Result Result Proceed to DTC is not output A DTC is output B
A
REPLACE ABSORBER CONTROL ECU Click here
B
GO TO VGRS SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here
-