DIFFERENTIAL MOUNT CUSHION INSTALLATION

PROCEDURE


  1. INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION


    1. Using SST, install a new rear No. 1 differential mount cushion.

      SST
      09316-12010
      09570-24011
      B002BRLC02
      *a Turn *b Hold
      *c 0° +/- 3° *d Paint mark
      B002B6O SST bolt lacation B002BBR Front of the Vehicle
      B002BRO Top of the Vehicle - -

      Note


      • Make sure that the deviation in the installation angle of the center of the No. 1 rear differential mount cushion and identification paint mark is within +/-3° of the vertical axis.

      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolts.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 1 differential mount cushion.

      • Do not tilt the bolts of SST.

      • Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.

      Tech Tips

      Install the 2 SST bolts to the 2 SST holes as shown in the illustration.

  2. INSTALL REAR NO. 2 DIFFERENTIAL MOUNT CUSHION


    1. Using SST, install a new rear No. 2 differential mount cushion.

      SST
      09316-12010
      09570-24011
      B002BWCE08
      Text in Illustration
      *a Turn *b Hold
      *c 0° +/- 3° *d Identification Paint Mark
      B002B6O SST bolt location B002BBR Front of Vehicle
      B002BRO Top of the Vehicle - -

      Note


      • Make sure that the deviation in the installation angle of the center of the No. 2 rear differential mount cushion and identification paint mark is within +/-3° of the vertical axis.

      • Temporarily install the rear No. 2 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.

      • Before using SST, apply grease to the SST bolt.

      • Be sure to use the correct combination of SST.

      • Make sure that SST (09527-17011) contacts the entire circumference of the rear No. 2 differential mount cushion.

      • Do not tilt the bolt of SST.

  3. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

    Click here