REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. DRAIN DIFFERENTIAL OIL

    Click here

  2. REMOVE REAR DRIVE SHAFT ASSEMBLY

    Click here

  3. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A000N4YE04
      Text in Illustration
      *1 Rear Differential Side Gear Shaft Oil Seal

      Using SST, remove the rear differential side gear shaft oil seal.

      SST
      09308-00010

  4. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL


    1. A000OQ1E01
      Text in Illustration
      *1 Rear Differential Side Gear Shaft Oil Seal
      *a -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Using SST and a hammer, install a new rear differential side gear shaft oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07200 )
      Oil seal installation depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note


      • Make sure to check the identification marks on the oil seals before installation because the part numbers differ between the left and right sides.

      • To ensure a proper seal, evenly tap in the rear differential side gear shaft oil seal.

      • When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.

  5. INSTALL REAR DRIVE SHAFT ASSEMBLY

    Click here

  6. ADD DIFFERENTIAL OIL

    Click here