REAR AXLE HUB ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE REAR DISC

    Click here

  4. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A000OF8

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If looseness exceeds the maximum, replace the axle hub assembly.

  5. INSPECT REAR AXLE HUB RUNOUT


    1. A000REN

      Using a dial indicator, check for runout on surface of the axle hub outside the hub bolt.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If runout exceeds the maximum, replace the axle hub assembly.

  6. INSTALL REAR DISC

    Click here

  7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  8. INSTALL REAR WHEEL

    Click here