SHIFT LEVER POSITION SENSOR INSTALLATION

PROCEDURE

INSTALL SHIFT LEVER POSITION SENSOR
Tech Tips

Make sure that the manual shaft has not been rotated prior to installing the shift lever position sensor as the detent spring may become detached from the manual shaft.
1. Temporarily install the shift lever position sensor to the hybrid vehicle transmission assembly with the 2 bolts.
  
  Tech Tips
  
  Tighten the bolt to the specified torque when adjusting the shift lever position sensor.
2. Install the lock plate and the lock nut to the shift lever position sensor.
  
  Torque:
  
  6.9 N*m { 70 kgf*cm, 61 in.*lbf }
3. Temporarily install the transmission control shaft lever to the shift lever position sensor with the spring washer and nut.
  
  Tech Tips
  
  Tighten the nut to the specified torque when adjusting the shift lever position sensor.
4. Turn the transmission control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.
5. Remove the nut, spring washer and transmission control shaft lever from the shift lever position sensor.
6. Text in Illustration
  
  *a Neutral Basic Line
  
  *b Groove
  
  Align the neutral basic line with the groove as shown in the illustration.
7. Hold the shift lever position sensor in that position and tighten the 2 bolts.
  
  Torque:
  
  5.4 N*m { 55 kgf*cm, 48 in.*lbf }
8. Using a screwdriver, stake the lock nut with the lock plate.
  
  Note
  
  Check that the lock nut is securely installed.
9. Install the transmission control shaft lever with floor shift gear shifting rod sub-assembly to the shift lever position sensor with the nut and spring washer.
  
  Torque:
  
  16 N*m { 160 kgf*cm, 12 ft.*lbf }
10. Connect the shift lever position sensor connector.
INSPECT SHIFT LEVER POSITION SENSOR

Click here
ADJUST SHIFT LEVER POSITION SENSOR

Click here
INSTALL NO. 2 ENGINE UNDER COVER

Click here
INSTALL FRONT SUSPENSION MEMBER BRACE

Click here

Text in Illustration
*a	Neutral Basic Line
*b	Groove