SHIFT LEVER ADJUSTMENT

PROCEDURE


  1. REMOVE EXHAUST PIPE ASSEMBLY FRONT

    Click here

  2. REMOVE FRONT NO.1 FLOOR HEAT INSULATOR

    Click here

  3. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. A000Q15

      Remove the nut and separate the floor shift gear shifting rod sub-assembly from the lever of the transmission floor shift assembly.

    3. A000R99E02

      Turn the transmission control shaft lever counterclockwise until it stops, then turn it clockwise 2 notches.

    4. A000MUD

      Temporarily install the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly with the nut.

      Text in Illustration
      B002B6O Push

    5. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly rearward.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

      Note

      Do not push the lever of the transmission floor shift assembly too hard.

  4. INSTALL FRONT NO.1 FLOOR HEAT INSULATOR

    Click here

  5. INSTALL EXHAUST PIPE ASSEMBLY FRONT

    Click here

  6. INSPECT SHIFT LEVER POSITION

    Click here