HYBRID TRANSMISSION REAR OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

    Click here

  2. REMOVE FLANGE YOKE ASSEMBLY


    1. A000OFPE02

      Using SST and a hammer, loosen the staked part of the lock nut.

      SST
      09930-00010

      Note


      • Be sure to use SST with the tapered surface facing the shaft.

      • Do not grind the tip of SST with a grinder or other device.

      • Completely loosen the staked part of the lock nut when removing it.

      • Do not damage the threads of the output shaft.

    2. A000P6QE02

      Using SST, secure the flange yoke assembly.

      SST
      09930-00010
      09330-00021
      09950-30012   ( 09955-03040 )

      Tech Tips

      Use an M8 x 1.25 bolt with an under head length of 45 mm to secure SST.

    3. A000R1PE01
      Text in Illustration
      *a Hold
      *b Turn

      Using a 30 mm deep socket wrench, remove the lock nut from the flange yoke assembly.

    4. Remove the flange yoke assembly from the output shaft.

    5. A000N1QE04
      Text in Illustration
      *1 Flange Yoke Type V Oil Seal
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the flange yoke type V oil seal from the flange yoke assembly.

  3. REMOVE EXTENSION HOUSING TYPE T OIL SEAL


    1. A000NVOE01

      Using SST, remove the extension housing type T oil seal from the hybrid vehicle transmission assembly.

      SST
      09308-00010

  4. INSTALL EXTENSION HOUSING TYPE T OIL SEAL


    1. Coat the lip of a new extension housing type T oil seal with a small amount of MP grease.

    2. A000RWIE02

      Using SST and a hammer, install the extension housing type T oil seal to the hybrid vehicle transmission assembly.

      SST
      09308-14010
      09309-14030
      Oil Seal Installation Depth
      4.3 to 4.7 mm (0.170 to 0.185 in.)

  5. INSTALL FLANGE YOKE ASSEMBLY


    1. A000SMZE01

      Using SST and a hammer, install a new flange yoke type V oil seal to the flange yoke assembly.

      SST
      09308-14030
      Oil Seal Installation Depth
      0 to 0.3 mm (0 to 0.0118 in.)

    2. Temporarily install the flange yoke assembly to the output shaft with a new lock nut.

    3. A000SY8E03
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, secure the flange yoke assembly.

      SST
      09308-14030
      09330-00021
      09950-30012   ( 09955-03040 )

    4. Using a 30 mm deep socket wrench, tighten the lock nut.

      Torque:
      126 N*m  { 1280 kgf*cm, 93 ft.*lbf }

    5. Using a chisel and hammer, stake the lock nut.

  6. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY

    Click here