FRONT AXLE HUB ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  3. REMOVE FRONT DISC (for 17 inch Front Disc Brake)

    Click here

  4. REMOVE FRONT DISC (for 18 inch Front Disc Brake)

    Click here

  5. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    1. A000STG

      Using a dial indicator, check for looseness near the center of the axle hub.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If looseness exceeds the maximum, replace the bearing.

  6. INSPECT FRONT AXLE HUB RUNOUT


    1. A000O1I

      Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.

      Maximum
      0.05 mm (0.0020 in.)

      Note

      Ensure that the dial indicator is set at right angles to the measurement surface.

      If runout exceeds the maximum, replace the axle hub.

  7. INSTALL FRONT DISC (for 17 inch Front Disc Brake)

    Click here

  8. INSTALL FRONT DISC (for 18 inch Front Disc Brake)

    Click here

  9. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

    Click here

  10. INSTALL FRONT WHEEL

    Click here