SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY


    1. Install the transmission floor shift assembly with the 4 bolts.

      Torque:
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

    2. Connect the 3 connectors and 5 clamps to the transmission floor shift assembly.

  2. INSTALL NO. 1 CONSOLE BOX DUCT


    1. Install the No. 1 console box duct with the 2 clips.

  3. CONNECT CENTER AIRBAG SENSOR ASSEMBLY

    Click here

  4. CONNECT FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


    1. A000S3LE13

      Turn the transmission control shaft lever RH of the park/neutral position switch assembly counterclockwise until it stops, and then turn it clockwise 2 notches to set it to N.

    2. A000QZO

      Move the shift lever to N and tighten the nut while lightly pushing the lever toward R.

      Text in Illustration
      B002BBR Push

      Note

      Do not push the shift lever too hard.

    3. After adjustment, check that the shift lever moves smoothly and the shift lever and gear operate correctly.

    4. Connect the floor shift gear shifting rod sub-assembly with the nut.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  5. INSTALL FRONT NO. 1 FLOOR HEAT INSULATOR

    Click here

  6. INSTALL FRONT EXHAUST PIPE ASSEMBLY

    Click here

  7. CONNECT HEATED OXYGEN SENSOR

    for Bank 1 Sensor 2: Click here

    for Bank 2 Sensor 2: Click here

  8. INSTALL FRONT CENTER FLOOR BRACE

    Click here

  9. INSTALL NO. 2 REAR FLOOR BOARD SUB-ASSEMBLY

    Click here

  10. INSTALL NO. 1 REAR FLOOR BOARD SUB-ASSEMBLY

    Click here

  11. INSPECT SHIFT LEVER POSITION

    Click here

  12. INSPECT FOR EXHAUST GAS LEAK