CRUISE CONTROL MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT CRUISE CONTROL MAIN SWITCH


    1. for Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        A000PTFE05
        Text in Illustration
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (ECC) - 3 (CCS) +RES 235 to 245 Ω
        1 (ECC) - 3 (CCS) -SET 617 to 643 Ω
        1 (ECC) - 3 (CCS) CANCEL 1509 to 1571 Ω
        1 (ECC) - 3 (CCS) Main switch off*1 1 MΩ or higher
        1 (ECC) - 3 (CCS) Main switch on Below 2.5 Ω

        • If the result is not as specified, replace the cruise control main switch.

    2. for Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        A000RUOE03
        Text in Illustration
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (ECC) - 3 (CCS) +RES 235 to 245 Ω
        1 (ECC) - 3 (CCS) -SET 617 to 643 Ω
        1 (ECC) - 3 (CCS) CANCEL 1509 to 1571 Ω
        1 (ECC) - 3 (CCS) Main switch off*1 1 MΩ or higher
        1 (ECC) - 3 (CCS) Main switch on Below 2.5 Ω

        • If the result is not as specified, replace the cruise control main switch.