EMISSION CONTROL SYSTEM(w/ Canister Pump Module) ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK FUEL CUT RPM


    1. Put the engine in inspection mode Click here.

    2. Start and warm up the engine.

    3. Increase the engine speed to at least 2500 rpm.

      Note

      When checking the fuel cut rpm, the transmission should be in park.

    4. Use a sound scope to check for injector operating sounds.

    5. When the accelerator pedal is released, check that injector operating sounds stop momentarily (at 2500 rpm or higher) and then resume (at 1400 rpm).

      Standard
      Item Specified Condition
      Fuel cut off rpm 2500 rpm or higher
      Fuel injection restart rpm 1400 rpm

      If the result is not as specified, check the injectors, wiring and ECM.

  2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS


    1. Visually check that the hoses, connections and gaskets have no cracks, leaks or damage.

      Tech Tips

      Detachment or other problems with the engine oil dipstick, filler cap, PCV hose and other components may cause the engine to run improperly.

      If any defects are found, replace parts as necessary.

  3. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM


    1. Put the engine in inspection mode Click here.

    2. Start the engine.

    3. A000O8Q

      Disconnect the fuel vapor feed hose shown in the illustration.

    4. Connect the GTS to the DLC3.

    5. Turn the GTS on.

    6. Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Evap Control.

    7. Check that vacuum occurs at the VSV port.

    8. Exit Active Test mode and reconnect the fuel vapor feed hose.

    9. Enter the following menus: Powertrain / Engine and ECT / Data List / EVAP Purge VSV.

    10. Warm up the engine and drive the vehicle.

    11. Confirm that the purge VSV opens.

      If the result is not as specified, replace the purge VSV, wire harness or ECM.

  4. CHECK FUEL TANK AND VENT LINE


    1. Disconnect the vent line hose from the canister.

    2. Connect the pressure gauge to the vent line hose.

      A000T2SE03
      Text in Illustration
      *1 Fuel Tank Cap *2 Vent Line Hose
      *3 Pressure Gauge - -

    3. Apply 4 kPa (0.04 kgf/cm2, 0.6 psi) of pressure to the vent line of the fuel tank.

      Tech Tips

      Perform this inspection with the fuel tank less than 90% full. When the fuel tank is full, the fuel fill check valve closes and the pressure is released through the 2 mm (0.0787 in.) orifice. As a result, when the fuel tank cap is removed, the pressure does not decrease smoothly.

    4. Check that the fuel tank pressure is maintained for some time, and does not decrease immediately.

      Tech Tips

      If the pressure decreases immediately, one of the following may apply:


      • The fuel tank cap is not completely tightened.

      • The fuel tank cap is damaged.

      • Air is leaking from the vent line.

      • The fuel tank is damaged.

    5. When the fuel tank cap is removed, check that the pressure is released smoothly.

      Tech Tips

      If the pressure does not drop, replace the fuel tank assembly.

    6. Reconnect the vent line hose to the canister.

  5. INSPECT AIR INLET LINE


    1. Disconnect the air inlet line hose from the charcoal canister.

    2. Check that air flows freely into the air inlet line.

      If air does not flow freely into the air inlet line, repair or replace the air inlet line hose.

    3. Reconnect the air inlet line hose to the charcoal canister.