FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) REMOVAL

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A000SREE01

      Disconnect the fuel sender gauge connector.

    2. Push the claw labeled A of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.

      Note


      • Do not touch the resistance plate or contacts of the fuel sender gauge assembly.

      • Do not bend the arm of the fuel sender gauge assembly.

  3. REMOVE REAR FLOOR SERVICE HOLE COVER


    1. A000PXN

      Remove the rear floor service hole cover.

    2. Disconnect the fuel sender gauge connector.

  4. REMOVE FUEL TANK VENT TUBE ASSEMBLY


    1. A000RPD

      Release the lock and remove the No. 1 fuel tube clamp.

      Text in Illustration
      B002BBR Front of Vehicle
    2. A000PCVE07
      Text in Illustration
      *1 Insertion Point

      Set the 2 claws and plate of SST on the fuel pump gauge retainer.

      SST
      09808-14030   ( 09808-01010, 09808-01030, 09808-01040 )

      Tech Tips

      Securely insert the ends of SST into the insertion points in the fuel pump gauge retainer.

    3. While firmly pressing the claws of SST into the insertion points in the fuel pump gauge retainer, tighten the bolts of the claws.

    4. Attach the handle of SST.

    5. A000R1FE03

      Using SST, loosen the fuel pump gauge retainer.

      Note


      • Do not use any tools other than SST, such as a screwdriver, etc.

      • Do not use excessive force when pressing down on SST, as the fuel pump gauge retainer will place excessive force on the fuel tank vent tube assembly and be difficult to remove, and parts may be damaged.

      • Be sure to keep the handle level when turning it, as SST may slip off the retainer if the handle is turned at an angle with excessive force.

      • Do not use an impact wrench or turn the handle with excessive force, as parts may be damaged.

      • If SST slips off the retainer, loosen the bolts and reattach SST to the retainer.

      • Make sure that the fuel suction tube set gasket does not come off.

    6. While pressing down on the fuel tank vent tube assembly with your hand, remove the fuel pump gauge retainer.

    7. A000N1S

      Disconnect the fuel return vent tube sub-assembly and remove the fuel tank vent tube assembly from the fuel tank assembly.

      Note

      When disconnecting the fuel tube connector, do not excessively pull on the fuel return vent tube sub-assembly.

    8. Remove the fuel suction tube set gasket from the fuel tank assembly.

  5. REMOVE NO. 2 FUEL SENDER GAUGE ASSEMBLY


    1. A000O7HE03

      Disconnect the fuel sender gauge connector.

    2. Push the claw labeled A of the No. 2 fuel sender gauge assembly, and then pull up the No. 2 fuel sender gauge assembly to remove it.

      Note


      • Do not touch the resistance plate or contacts of the No. 2 fuel sender gauge assembly.

      • Do not bend the arm of the No. 2 fuel sender gauge assembly.