INJECTOR DRIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER

    Click here

  6. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  7. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  9. REMOVE NO. 1 ENGINE COVER


    1. A000NXA

      Remove the 3 clips and No. 1 engine cover.

  10. REMOVE INJECTOR DRIVER


    1. A000P4PE04
      Text in Illustration
      *1 Lock Lever
      *a Release
      *b Lock with Connector

      Move the lock levers in the direction indicated by the arrow to release the 3 connector locks. Disconnect the 4 connectors from the injector driver.

    2. A000SQYE01
      Text in Illustration
      *1 Bolt
      *2 Nut

      Remove the bolt, 2 nuts and injector driver.

      Note

      Be careful not to drop or strike the injector driver.