FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free of foreign matter.

    2. A000N31E02
      Text in Illustration
      *1 Depth

      Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain case edge.

      SST
      09223-22010
      09506-35010
      Standard depth
      0 to 1.0 mm (0 to 0.0394 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. Install the pulley set key to the key groove.

  3. INSTALL CRANKSHAFT PULLEY


    1. A000QIWE02
      Text in Illustration
      *a Hold
      *b Turn

      Align the pulley set key with the key groove of the pulley, and slide on the pulley.

    2. Using SST, install the crankshaft pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

  4. CONNECT WIRE HARNESS


    1. Install the wire harness bracket with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    2. Connect the engine oil pressure switch connector.

  5. INSTALL FAN AND GENERATOR V BELT

    Click here

  6. INSTALL FAN SHROUD

    Click here

  7. INSPECT FOR OIL LEAK

    Click here