FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE FAN SHROUD

    Click here

  2. REMOVE FAN AND GENERATOR V BELT

    Click here

  3. DISCONNECT WIRE HARNESS


    1. A000OO1

      Disconnect the engine oil pressure switch connector.

    2. Remove the bolt and disconnect the wire harness bracket.

  4. REMOVE CRANKSHAFT PULLEY


    1. A000PZLE02
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, loosen the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
    2. A000QKVE01
      Text in Illustration
      *a Hold
      *b Turn

      Tighten the pulley bolt to 2 or 3 threads of the crankshaft.

    3. Using SST, remove the pulley bolt and pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply grease to the threads and tip of SST (center bolt) prior to use.

  5. REMOVE CRANKSHAFT TIMING GEAR KEY


    1. A000Q9T

      Remove the pulley set key of the key groove.

  6. REMOVE TIMING CHAIN CASE OIL SEAL


    1. A000QUIE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip taped, pry out the oil seal.

      Note

      After the removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.