DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. A000P17E01
      Text in Illustration
      *1 Engine Water Pump
      *2 Tensioner
      *3 Crankshaft

      Set the fan and generator V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the 5 mm bi-hexagon wrench.

      Note


      • Put the backside of the fan and generator V belt on the tensioner pulley and idler pulley.

      • Check that the fan and generator V belt is properly set to each pulley.

    3. If it is difficult to install the fan and generator V belt, perform the following procedure.


      1. Put the fan and generator V belt on every part except the tensioner pulley.

      2. Put the fan and generator V belt on the tensioner pulley while turning the belt tensioner counterclockwise.

        Note


        • Put the backside of the fan and generator V belt on the tensioner pulley and idler pulley.

        • Check that the fan and generator V belt is properly set to each pulley.

    4. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  3. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  5. INSTALL ENGINE ROOM SIDE COVER

    Click here