CYLINDER BLOCK REPLACEMENT

PROCEDURE


  1. REPLACE RING PIN

    Note

    If a ring pin is deformed or damaged, replace it.


    1. Remove the 12 ring pins.

    2. Using a plastic-faced hammer, install 12 new ring pins.

      A000Q0HE03
      Text in Illustration
      *a Upper Side *b Lower Side
      *c 15 mm (0.591 in.) *d 12 mm (0.472 in.)
      *e 13 mm (0.512 in.) *f Protrusion Height
      Standard Protrusion Height
      Item Specified Condition
      A 5.0 to 7.0 mm (0.197 to 0.276 in.)
      B 4.0 to 7.0 mm (0.157 to 0.276 in.)

  2. REPLACE STRAIGHT PIN

    Note

    If a straight pin is deformed or damaged, replace it.


    1. Remove the 8 straight pins.

    2. Using a plastic-faced hammer, install 8 new straight pins.

      A000OMME02
      Text in Illustration
      *a Front Side *b Rear Side
      *c LH Side *d Lower Side
      *e 22 mm (0.866 in.) *f 10 mm (0.394 in.)
      *g 14 mm (0.551 in.) *h 6 mm (0.236 in.)
      *i Protrusion Height - -
      Standard Protrusion Height
      Item Specified Condition
      A 11.0 to 13.0 mm (0.433 to 0.512 in.)
      B 5.0 to 7.0 mm (0.197 to 0.276 in.)