FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL


    1. Apply MP grease to the lip of a new timing gear case or timing chain case oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    2. A000RV1E01
      Text in Illustration
      *a Depth

      Using SST and a hammer, tap in the timing gear case or timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.

      SST
      09636-20010
      Standard depth
      0.75 to 1.45 mm (0.0295 to 0.0571 in.)

      Note


      • Do not tap in the timing gear case or timing chain case oil seal at an angle.

      • Keep the lip free from foreign matter.

      • Wipe off any MP grease from the crankshaft.

  2. INSTALL CRANKSHAFT PULLEY ASSEMBLY


    1. Align the crankshaft pulley set crankshaft key with the key groove of the crankshaft pulley assembly.

    2. A000OCQE02
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley assembly and install the crankshaft pulley set bolt.

      SST
      09213-54015
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

      Tech Tips

      SST (Crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)

  3. INSTALL FAN AND GENERATOR V BELT

    Click here

  4. INSTALL FAN SHROUD

    Click here

  5. INSPECT FOR OIL LEAK

    Click here