DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT

    Tech Tips

    When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.


    1. A000STL

      Partially mount the fan and generator V belt on the engine water pump assembly as shown in the illustration. Mount the fan and generator V belt around the engine water pump assembly partially as shown in the illustration.

      Note


      • Make sure the fan and generator V belt is securely mounted on the crankshaft pulley assembly.

      • Do not allow slack in the fan and generator V belt.

    2. A000PI7

      While holding the fan and generator V belt on the engine water pump assembly by hand as shown in the illustration, gradually rotate the crankshaft pulley assembly clockwise to mount the fan and generator V belt on the engine water pump assembly.

      CAUTION:

      Do not hold any other parts of the fan and generator V belt, or your fingers may get caught between the fan and generator V belt and engine water pump assembly as they are rotated.

      Note


      • Guide the fan and generator V belt into the grooves of the engine water pump assembly as the crankshaft pulley assembly is rotated.

      • Make sure the fan and generator V belt is not inside out.

    3. A000QYEE01
      Text in Illustration
      *a Correct
      *b Incorrect

      Rotate the crankshaft pulley assembly until the fan and generator V belt is fully mounted on the engine water pump assembly.

    4. Check that the fan and generator V belt is securely mounted on the crankshaft pulley assembly and engine water pump assembly.

      Note

      Make sure the ribs of the fan and generator V belt are not cracked.

    5. Start the engine and check that the fan and generator V belt turns smoothly without any noise.

  2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. INSTALL NO. 1 AIR CLEANER INLET

    Click here

  4. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  5. INSTALL ENGINE ROOM SIDE COVER

    Click here