REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE HYBRID VEHICLE TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A000NNYE02

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)

    2. A000PJY

      Remove the 6 bolts and transmission input damper assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A000NNYE02

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) fixing bolt part No.: 91551-80650 (2 pcs)

    2. A000T19

      Remove the 8 bolts and flywheel sub-assembly.

  4. REMOVE REAR ENGINE OIL SEAL


    1. A000QXAE03
      Text in Illustration
      *a Protective Tape
      *b Cut Position

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note

      Do not damage the surface of the press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.