WATER PUMP WITH MOTOR REMOVAL

PROCEDURE


  1. REMOVE ENGINE ROOM SIDE COVER

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  4. REMOVE AIR CLEANER CAP WITH NO. 2 AIR CLEANER HOSE

    Click here

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  7. REMOVE ENGINE UNDER COVER

    Click here

  8. DRAIN COOLANT (for Inverter)

    Click here

  9. REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY


    1. A000MW0

      Detach the inverter cooling hose clamp from the inverter water pump with motor assembly.

    2. Slide the 2 clamps and disconnect the hybrid water pump inlet hose and No. 1 hybrid water pump outlet hose from the inverter water pump with motor assembly.

      Note

      Apply insulating tape to the pipe and in the disconnected hose or cover the pipe and hose with plastic bags to prevent entry of foreign matter.

    3. A000PY3

      Detach the 2 clamps and disconnect the inverter water pump connector.

      Note

      Wipe off any coolant from the connectors of the wire harness and inverter water pump with motor, and apply insulating tape to protect them from coolant.

    4. A000NRS

      Remove the 2 bolts and HV water pump bracket sub-assembly.

  10. REMOVE INVERTER WATER PUMP WITH MOTOR ASSEMBLY


    1. A000O13

      Remove the 3 bolts and inverter water pump with motor assembly from the HV water pump bracket sub-assembly.