IGNITION COIL AND SPARK PLUG REMOVAL

PROCEDURE


  1. REMOVE ENGINE ROOM SIDE COVER

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  4. DISCONNECT NO. 2 VENTILATION HOSE

    Click here

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  6. REMOVE IGNITION COIL ASSEMBLY


    1. A000OJ2

      for RHD:

      Detach the 2 wire harness clamps from the inverter bracket.

    2. A000SIH

      for RHD:

      Remove the 2 bolts and inverter bracket from the inverter.

    3. A000Q09

      Remove the 2 bolts and disconnect the inverter reservoir tank assembly.

    4. A000RNNE01

      for Bank 1:


      1. Remove the 3 nuts and disconnect the clamp labeled A using a clip remover. Then, disconnect the clamp labeled B using needle-nose pliers.

        Note

        Do not damage the claws of the clamp.

      2. Disconnect the manifold absolute pressure sensor connector, VVT sensor connector and 3 ignition coil connectors to disconnect the engine wire.

      3. Remove the 3 bolts and 3 ignition coils.

    5. A000QQ7

      for Bank 2:


      1. Remove the 2 nuts and disconnect the clamp.

      2. Disconnect the VVT sensor connector and 3 ignition coil connectors to disconnect the engine wire.

      3. Remove the 3 bolts and 3 ignition coils.

  7. REMOVE SPARK PLUG


    1. Remove the 6 spark plugs.