HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR


    1. A000O2QE02
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00011
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

      • Make sure SST and the wrench are connected in a straight line.

    2. Connect the clamp.

    3. Connect the heated oxygen sensor connector.

  2. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  3. INSTALL FRONT SUSPENSION MEMBER BRACE

    Click here

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here