ENGINE COOLANT TEMPERATURE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR

   
   

   1. Install a new gasket onto the engine coolant temperature sensor.

   2. Using a 19 mm ball joint lock nut wrench, install the engine coolant temperature sensor to the water outlet sub-assembly.

      Torque:

      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      
      

      • If an engine coolant temperature sensor has been struck or dropped, replace it.

      • Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench Click here.

      Tech Tips

      Perform "Inspection After Repair" after replacing an engine coolant temperature sensor.

      
      

      • w/ EGR System: Click here

      • w/o EGR System: Click here

   3. Connect the engine coolant temperature sensor connector.

2. CONNECT ENGINE WIRE

   
   

   1. Connect the engine wire with the 3 wire harness clamps.

3. ADD ENGINE COOLANT

   Click here

4. INSPECT FOR ENGINE COOLANT LEAK

   Click here

5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

   Click here