CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

1. INSTALL CRANKSHAFT POSITION SENSOR

   
   

   1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

   2. Install the crankshaft position sensor to the timing chain cover assembly with a new bolt.

      Torque:

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      
      

      • If a crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place during installation.

   3. Connect the crankshaft position sensor connector.

2. INSTALL NO. 1 AIR CLEANER INLET

   Click here

3. INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

4. INSTALL ENGINE ROOM SIDE COVER

   Click here