THROTTLE BODY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.


PROCEDURE


  1. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A000QFME01
      Text in Illustration
      *a Protrusion

      Install a new throttle body gasket onto the intake manifold with the protrusion of the throttle body gasket oriented as shown in the illustration.

    2. Install the throttle body with motor assembly to the intake manifold with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Tech Tips

      Perform "Inspection After Repairs" after replacing the throttle body with motor assembly.


    3. Connect the No. 2 water by-pass hose and No. 3 water by-pass hose to the throttle body with motor assembly, and slide the 2 clamps to secure the hoses.

    4. Connect the throttle body with motor assembly connector.

  2. INSTALL AIR CLEANER HOSE ASSEMBLY


    1. A000RX4E02
      Text in Illustration
      *a Cutout
      *b Protrusion

      Align the cutout of the air cleaner hose assembly with the protrusion of the throttle body with motor assembly, and install the air cleaner hose assembly.

    2. Tighten the hose clamp.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

      Note

      Fit the protrusion on the air cleaner hose assembly into the hole of the hose clamp.

    3. Connect the ventilation hose to the throttle body with motor assembly, and slide the clamp to secure the hose.

  3. INSTALL AIR CLEANER CAP WITH NO. 2 AIR CLEANER HOSE


    1. A000T1PE01
      Text in Illustration
      *a Groove
      *b Matchmark

      Connect the air cleaner cap with No. 2 air cleaner hose to the air cleaner hose assembly.

      Tech Tips

      Make sure the direction of the installation is as shown in the illustration.

    2. Attach the 4 clamps to install the air cleaner cap with No. 2 air cleaner hose.

    3. Tighten the hose clamp.

      Torque:
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

    4. Connect the wire harness clamp to the air cleaner cap with No. 2 air cleaner hose.

    5. Connect the mass air flow meter sub-assembly connector.

  4. ADD ENGINE COOLANT

    Click here

  5. INSPECT FOR ENGINE COOLANT LEAK

    Click here

  6. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  7. INSTALL ENGINE ROOM SIDE COVER

    Click here

  8. PERFORM INITIALIZATION

    Note

    Be sure to perform this procedure after removing and reinstalling the throttle body with motor assembly.


    1. Connect the GTS to the DLC3.

    2. Clear the DTCs.


    3. Turn the power switch on (IG) without operating the accelerator pedal.

      Note

      If the accelerator pedal is operated, perform the above steps again.

    4. Perform "Inspection After Repair".


    5. Put the engine in inspection mode (maintenance mode) Click here.

    6. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

      Standard
      950 to 1050 rpm

      Note


      • Be sure to perform this step with all accessories off.

      • Make sure that the shift lever is in P.

    7. Perform a road test and confirm that there are no abnormalities.