SFI SYSTEM(w/o EGR System), Diagnostic DTC:P0630

DTC Code DTC Name
P0630 VIN not Programmed or Mismatch - ECM / PCM

DESCRIPTION

DTC P0630 is set when the VIN is not stored in the ECM or the input VIN is not accurate. Input the VIN with the GTS.

DTC No. DTC Detection Condition Trouble Area
P0630

Either of the following conditions is met (1 trip detection logic):


  • VIN not stored in ECM

  • Input VIN in ECM not accurate

 ECM

MONITOR STRATEGY

Required Sensors/Components (Main) ECM
Required Sensors/Components (Related) -
Frequency of Operation Continuous

CONFIRMATION DRIVING PATTERN


  1. Connect the GTS to the DLC3.

  2. Turn the power switch on (IG) and turn the GTS on.

  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure) Click here.

  4. Turn the power switch off and wait for 30 seconds.

  5. Turn the power switch on (IG) and turn the GTS on.

  6. Wait 5 seconds or more.

  7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  8. Read Pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  9. Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.

  10. Input the DTC: P0630.

  11. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions
    N/A

    • Unable to perform DTC judgment

    • Number of DTCs which do not fulfill DTC preconditions has reached ECU's memory limit

    Tech Tips


    • If the judgment result shows NORMAL, the system is normal.

    • If the judgment result shows ABNORMAL, the system has a malfunction.

CAUTION / NOTICE / HINT

Tech Tips

Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. READ DTC OUTPUT (DTC P0630)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    5. Read the DTCs.

      Result
      Result Proceed to
      DTC P0630 is output A
      DTC P0630 and other DTCs are output B

      Note

      If P0630 is set, the VIN must be input to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when inputting the VIN. If DTCs other than P0630 are set, check them first.

      Tech Tips

      If any DTCs other than P0630 are output, troubleshoot those DTCs first.


    B

    GO TO DTC CHART Click here

    A

  2. INPUT VIN


    1. Input the VIN Click here.


    NEXT

    END