OUTER REAR VIEW MIRROR GLASS INSPECTION

PROCEDURE


  1. INSPECT OUTER MIRROR LH


    1. A000MSDE01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror LH)

      Check the mirror heater.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 3.5 to 4.9 Ω

        If the result is not as specified, replace the outer mirror LH.

    2. A000QM0E01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror LH)
      *b EC Mirror Connector

      w/ Blind Spot Monitor:

      Note

      Do not apply auxiliary battery voltage to the EC mirror connector.


      1. Apply auxiliary battery voltage to the terminals of the connector, and check the blind spot monitor indicator operation.

        OK
        Tester Connection Specified Condition

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Blind spot monitor indicator comes on

        If the result is not as specified, replace the outer mirror LH.

    3. Check the EC mirror operation.


      1. Connect 1.5 V dry-cell battery.

      2. A000SUBE01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror LH)

        Apply 1.5 V battery voltage and check the EC mirror operation.

        Note

        Do not apply a voltage of 1.5 V or higher.

        OK
        Measurement Connection Specified Condition

        Positive (+) end of the battery → Terminal 1

        Negative (-) end of the battery → Terminal 2

        		 Mirror surface becomes dark

        If the result is not as specified, replace the outer mirror LH.

  2. INSPECT OUTER MIRROR RH


    1. A000QNZE01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror RH)

      Check the mirror heater.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 3.5 to 4.9 Ω

        If the result is not as specified, replace the outer mirror RH.

    2. A000OF1E01
      Text in Illustration
      *a

      Component without harness connected

      (Outer Mirror RH)
      *b EC mirror connector

      w/ Blind Spot Monitor:

      Note

      Do not apply auxiliary battery voltage to the EC mirror connector.


      1. Apply auxiliary battery voltage to the terminals of the connector, and check the blind spot monitor indicator operation.

        OK
        Tester Connection Specified Condition

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Blind spot monitor indicator comes on

    3. Check the EC mirror operation.


      1. Connect 1.5 V dry-cell battery.

      2. A000RJUE01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror RH)

        Apply 1.5 V battery voltage and check the EC mirror operation.

        Note

        Do not apply a voltage of 1.5 V or higher.

        OK
        Measurement Connection Specified Condition

        Positive (+) end of the battery → Terminal 1

        Negative (-) end of the battery → Terminal 2

        		 Mirror surface becomes dark

        If the result is not as specified, replace the outer mirror RH.