HOOD LOCK CONTROL CABLE ASSEMBLY(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A000RAEE01
      Text in Illustration
      *1 String

      Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly as shown in the illustration.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. Pass the hood lock control cable assembly through the vehicle body, and then attach each clamp.

    3. Untie the string from the hood lock control cable assembly.

      A000T4FE02
      Text in Illustration
      *A w/o Cover *B w/ Cover
      *1 Hood Lock Control Cable *2 Stopper

  2. INSTALL NO. 2 HOOD LOCK CONTROL CABLE COVER (w/ Cover)


    1. Attach the claw to install the No. 2 hood lock control cable cover.

    2. Install the screw.

  3. INSTALL HOOD LOCK CONTROL CABLE COVER (w/ Cover)


    1. Attach the guide to install the hood lock control cable cover.

  4. INSTALL UPPER RADIATOR SUPPORT (w/ Cover)


    1. Install the upper radiator support with the 5 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect each connector.

    3. Attach the 2 claws and install the 2 screws.

  5. INSTALL NO. 1 AIR CLEANER INLET (w/ Cover)

    Click here

  6. INSTALL HOOD LOCK ASSEMBLY


    1. Connect the hood lock control cable to the hood lock assembly.

    2. Install the hood lock with the 3 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  7. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR


    1. Install the hood lock release lever protector with the 2 clips.

    2. Attach the 2 clamps and connect the connector.

  8. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable to the hood lock control lever sub-assembly.

    2. Attach the 3 claws to install the hood lock control lever sub-assembly.

  9. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  10. INSTALL FRONT FENDER UPPER PROTECTOR LH


    1. Attach the 3 clips to install the front fender upper protector LH.

  11. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  12. INSTALL ENGINE ROOM SIDE COVER

    Click here