BACK WINDOW GLASS REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE REAR SEAT ASSEMBLY

    Click here

  6. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  7. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  8. REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)

    Click here

  9. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH

    Click here

  10. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. REMOVE AMPLIFIER ANTENNA ASSEMBLY

    Click here

  12. REMOVE BACK WINDOW GLASS

    Note

    As the stopper, bracket and harness are not supplied individually, be careful not to damage them when installing the back window glass.

    A000QFCE03
    Text in Illustration
    *A 1-piece type
    *B 2-piece type
    *1 No. 1 Back Window Glass Stopper
    *2 No. 2 Back Window Glass Stopper

    1. A000SWZE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the outer surface of the vehicle body to prevent scratches.

    2. Disconnect the connectors.

    3. From the interior, insert a piano wire between the vehicle body and back window glass as shown in the illustration.

      Note


      • If the stopper is damaged, the back window glass assembly must be replaced. Be careful when performing the procedure.

      • Make sure not to deform the upper brackets.

      • Make sure not to damage the wire harness.

    4. Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.

    5. Place matchmarks over the glass and vehicle body on the locations indicated in the illustration.

      Tech Tips

      Matchmarks do not need to be placed if the glass is not going to be reused.

    6. A000PIKE03
      Text in Illustration
      *1 Stopper
      *2 Piano Wire

      Cut through the adhesive by pulling the piano wire around the back window glass.

      Note

      Leave as much adhesive on the vehicle body as possible when removing the back window glass.

    7. Using suction cups, remove the back window glass.

      Note

      If the stopper is damaged, the back window glass assembly must be replaced. Be careful when performing the procedure.

  13. REMOVE NO. 1 BACK WINDOW GLASS STOPPER


    1. A000QKA

      Remove the 2 No. 1 back window glass stoppers.