CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL ASSEMBLY LH
REMOVE REAR DOOR HOLE COVER
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
REMOVE REAR DOOR GLASS INNER WEATHERSTRIP LH
REMOVE REAR DOOR NO. 1 STIFFENER CUSHION
REMOVE REAR DOOR TRIM COVER LH
REMOVE REAR SIDE CURTAIN ASSEMBLY LH (w/ Rear Sunshade)
REMOVE REAR DOOR FRAME GARNISH LH
REMOVE REAR DOOR ARMREST SET BRACKET LH
REMOVE REAR DOOR SERVICE HOLE COVER LH
REMOVE REAR NO. 2 SPEAKER ASSEMBLY
REMOVE REAR DOOR GLASS RUN LH
REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.