POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

   Click here

3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Click here

6. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL LH (for Driver Side)

   Click here

7. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT UPPER ARMREST BASE PANEL RH (for Front Passenger Side)

   Click here

8. REMOVE FRONT DOOR HOLE COVER

   Click here

9. REMOVE COURTESY LIGHT ASSEMBLY

   Click here

10. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

11. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

12. REMOVE FRONT DOOR ARMREST SET BRACKET LH

    Click here

13. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

14. REMOVE DOOR FRAME GARNISH LH

    Click here

15. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

16. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

    Click here

17. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

    
    

    1. 

       Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.