ROOF HEADLINING DISASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE VANITY LIGHT ASSEMBLY

    Tech Tips

    Use the same procedure for both vanity light assemblies.


    1. B002BIBE03
      Text in Illustration
      *1 Bulb Holder
      *2 Claw A
      *3 Claw B

      Detach the 2 claws (A) and separate the bulb holder from the vanity light assembly as shown in the illustration.

    2. Detach the claw (B) and remove the vanity light assembly.

  2. REMOVE NO. 1 ROOF WIRE


    1. w/ Sliding Roof:


      1. B002BPC

        Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Detach the clamps.

      3. Remove each piece of tape and the No. 1 roof wire from the roof headlining.

      4. Remove the butyl tape remaining on the roof headlining.

        B002BB3E01
        Text in Illustration
        *A w/ Rain Sensor, for LHD *B w/ Rain Sensor, for RHD
        *C w/o Pre-crash Safety System *D w/ Pre-crash Safety System
        *E w/ Camera Heater - -
        B002BQR Tape - -

    2. w/o Sliding Roof:


      1. B002BPC

        Turn the visor connectors approximately 90° clockwise and remove them from the roof headlining.

      2. Detach the clamps.

      3. Remove each piece of tape and the No. 1 roof wire from the roof headlining.

      4. Remove the butyl tape remaining on the roof headlining.

        B002C3VE01
        Text in Illustration
        *A w/ Rain Sensor, for LHD *B w/ Rain Sensor, for RHD
        *C w/o Pre-crash Safety System *D w/ Pre-crash Safety System
        *E w/ Camera Heater - -
        B002BQR Tape - -