HEATER WATER PUMP(for 2GR-FXE) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE ENGINE ROOM SIDE COVER

    Click here

  6. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  7. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  8. REMOVE ENGINE UNDER COVER

    Click here

  9. DRAIN ENGINE COOLANT

    Click here

  10. REMOVE NO. 1 AIR CLEANER INLET

    Click here

  11. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  12. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  13. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  14. REMOVE OIL PUMP MOTOR CONTROLLER

    Click here

  15. REMOVE HEATER ACCESSORY ASSEMBLY


    1. A000PEX

      Detach the clamp and disconnect the connector.

    2. A000O9B

      Detach the 3 clamps and remove the bolt.

    3. A000NKBE01

      Using pliers, grip the claws of the clip and slide the clip.

    4. Disconnect the heater water outlet hose C.

      Text in Illustration
      *1 Heater Water Outlet Hose C
    5. A000MYOE01

      Using pliers, grip the claws of the clip and slide the clip.

    6. Disconnect the heater water inlet hose C and remove the heater accessory assembly (heater water pump).

      Text in Illustration
      *1 Heater Water Inlet Hose C