ION GENERATOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  4. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  6. REMOVE NO. 1 ION GENERATOR SUB-ASSEMBLY

    A000R07

    1. Detach the clamp.

    2. Remove the 2 screws and No. 1 ion generator sub-assembly.

    3. A000RMPE02
      Text in Illustration
      *1 Rear Air Duct Sub-assembly

      Detach the 2 claws and remove the rear air duct sub-assembly.

  7. REMOVE AIR DUCT SUB-ASSEMBLY

    A000P1U

    1. Detach the 2 claws.

    2. Remove the clip and air duct sub-assembly.