REAR SEAT INNER BELT ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  5. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

  6. REMOVE REAR SEAT HEADREST ASSEMBLY

    Click here

  7. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

  8. REMOVE BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  13. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    1. A000R6P

      Using a moulding remover, detach the 4 claws and remove the 2 rear seat shoulder belt hole covers.

    2. A000ROA

      Using a moulding remover, detach the 4 claws and remove the belt guide of the rear seat inner with center belt assembly LH.

    3. A000NWF

      Using a moulding remover, detach the 4 claws and remove the 3 child restraint tether anchor covers.

    4. w/o Rear Sunshade:


      1. A000NHG

        Detach the 4 claws, disconnect the connector and remove the center stop light cover.

      2. A000QUR

        Detach the 4 clips, and then slide the package tray trim panel assembly towards the front of the vehicle to detach the 5 guides.

      3. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly and remove the package tray trim panel assembly.

    5. w/ Rear Sunshade:


      1. A000QRO

        Detach the 4 clips, and then slide the package tray trim panel assembly towards the front of the vehicle to detach it from the rear window shade assembly.

      2. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly and remove the package tray trim panel assembly.

  16. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH


    1. A000RAJ

      Disconnect the connector.

    2. Remove the bolt and rear seat inner with center belt assembly RH.

  17. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    1. A000OHH

      Remove the 2 bolts.

    2. Detach the guide and remove the rear seat inner with center belt assembly LH.