FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE FRONT DOOR SCUFF PLATE LH

    Click here

  3. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  6. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH


    1. A000R12

      Detach the 6 hooks and remove the seat belt anchor cover cap LH.

    2. Operate the power seat switch assembly and move the front seat assembly so that the nut for the anchor of the front seat outer belt assembly LH can be removed.

    3. A000OFV

      Remove the nut and disconnect the anchor of the front seat outer belt assembly LH.

  7. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  8. REMOVE LOWER CENTER PILLAR GARNISH LH

    Click here

  9. REMOVE UPPER CENTER PILLAR GARNISH LH

    Click here

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    1. A000MSO

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A000QX5E03
      Text in Illustration
      *1 Pretensioner Connector

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect the connector (w/o Pre-crash Safety System) or 2 connectors (w/ Pre-crash Safety System).

    4. Remove the 2 bolts and front seat outer belt assembly LH.

  11. REMOVE FRONT SEAT BELT RETRACTOR COVER LH

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A000NK2

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.