REAR CONTROL SWITCH REASSEMBLY

PROCEDURE


  1. INSTALL COOLER CONTROL SWITCH KNOB

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    SST
    09890-47010   ( 09891-04020, 09891-04010, 09891-04030, 09891-04040 )

    1. Install the rubber switch to the cooler control switch knob.

    2. B002BYT

      Install the circuit board sub-assembly with the 3 screws.

      Note


      • When replacing the cooler control switch knob, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the circuit board sub-assembly from being damaged.

      • Do not damage the circuit board sub-assembly.

    3. B002BJ0

      Install the cooler control switch knob to the cooler control case.

      Note


      • When replacing the cooler control switch knob, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the circuit board sub-assembly from being damaged.

      • Do not damage the circuit board sub-assembly.

  2. INSTALL COOLER CONTROL SWITCH PANEL

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop anti-static mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    SST
    09890-47010   ( 09891-04020, 09891-04010, 09891-04030, 09891-04040 )

    1. Attach the 12 claws to install the cooler control switch panel.

    2. Install the 3 screws.