HEADLIGHT ECU REMOVAL

CAUTION / NOTICE / HINT

Note


  • Be sure to read Precaution thoroughly before servicing Click here.

  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

  • Do not reuse parts which have reduced fastening ability due to thread damage.

  • When installing components, make sure that the wire harness is not pinched or pulled.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE HEADLIGHT ASSEMBLY LH

    for Single Beam Headlight:

    Click here

    for Triple Beam Headlight:

    Click here

  2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY LH

    Note


    • If the headlight ECU sub-assembly LH has been dropped , replace it with a new one.

    • If the headlight ECU sub-assembly LH has been removed, replace the headlight gasket with a new one.


    1. Remove the 3 screws and headlight ECU sub-assembly LH.

      B002BDEE01
      Text in Illustration
      *A for Single Beam Headlight, w/o AFS *B

      for Single Beam Headlight, w/ AFS

      for Triple Beam Headlight

    2. Disconnect the connector cover.

      B002BEIE01
      Text in Illustration
      *A for Single Beam Headlight, w/o AFS *B

      for Single Beam Headlight, w/ AFS

      for Triple Beam Headlight

    3. Disconnect each connector.

      B002BMAE01
      Text in Illustration
      *A for Single Beam Headlight, w/o AFS *B

      for Single Beam Headlight, w/ AFS

      for Triple Beam Headlight

  3. REMOVE HEADLIGHT GASKET

    Note

    If the headlight gasket has been removed, replace it with a new one.


    1. Remove the headlight gasket.

      B002C0IE01
      Text in Illustration
      *A for Single Beam Headlight, w/o AFS *B

      for Single Beam Headlight, w/ AFS

      for Triple Beam Headlight