AHS ECU INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

  • Do not reuse parts which have reduced fastening ability due to thread damage.

  • When installing components, make sure that the wire harness is not pinched or pulled.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL HEADLIGHT GASKET

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • If the headlight gasket has been removed, replace it with a new one.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. Install a new headlight gasket.

  2. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

    Note


    • Prevention of static electricity is required during this procedure.

    • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

    • If the headlight light control ECU sub-assembly LH has been dropped , replace it with a new one.

    • If the headlight light control ECU sub-assembly LH has been removed, replace the headlight gasket with a new one.

    SST
    09890-47010   ( 09891-04010, 09891-04020, 09891-04030, 09891-04040 )

    1. Connect the 2 connectors.

    2. Return the connector cover to its original position.

    3. Install the headlight light control ECU sub-assembly LH with the 3 screws.

  3. INSTALL HEADLIGHT ASSEMBLY LH

    Click here