AUTOMATIC LIGHT CONTROL SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE UPPER INSTRUMENT CLUSTER FINISH PANEL

    Click here

  6. REMOVE MULTI-DISPLAY (for 8 Inch)

    Click here

  7. REMOVE ACCESSORY METER ASSEMBLY (for 12.3 Inch)

    Click here

  8. REMOVE AUTOMATIC LIGHT CONTROL SENSOR


    1. A000SZ5

      Detach the 2 claws and remove the automatic light control sensor.

    2. Disconnect the connector.