VEHICLE APPROACHING SPEAKER SWITCH REMOVAL

PROCEDURE

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

Click here
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

Click here
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

Click here
REMOVE BATTERY SERVICE HOLE COVER LH

Click here
PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

Click here
DISABLE AUTOAWAY/RETURN FUNCTION
1. Disable the autoaway/return function by changing the customize parameter.
  
  Click here
  
  Note
  
  Record the current customize parameter setting (whether the autoaway/return function is enabled or disabled) in order to restore the current setting after finishing the operation.
  
  Tech Tips
  
  Performing the above operation causes the autoaway/return function to be disabled when the power switch is turned off.
2. Turn the power switch on (IG). Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.
3. Turn the power switch off.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
1. Disconnect the cable from the negative (-) auxiliary battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
  
  Note
  
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
  
  Click here
REMOVE INSTRUMENT SIDE PANEL LH

Click here
REMOVE INSTRUMENT PANEL ORNAMENT

Click here
REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here
REMOVE VEHICLE APPROACHING SPEAKER SWITCH
1. Detach the 2 claws and remove the vehicle approaching speaker switch.