REAR DOOR SUNSHADE ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT REAR CURTAIN SUB-ASSEMBLY LH

    A000YPUE05
    Text in Illustration
    *a

    Component without Harness Connected

    (Rear Curtain Sub-assembly LH)

    1. Apply battery voltage and check the operation of the rear curtain sub-assembly LH.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (SSA+)

      Battery negative (-) → 1 (SSA-)

      		 Rear curtain sub-assembly LH raises

      Battery positive (+) → 1 (SSA-)

      Battery negative (-) → 2 (SSA+)

      		 Rear curtain sub-assembly LH lowers

      CAUTION:

      Be careful when the rear curtain sub-assembly LH raises and lowers. Something could get caught in the rear curtain sub-assembly LH and cause an injury.

      Tech Tips

      To prevent the motor from burning out, stop operation as soon as the rear curtain sub-assembly LH is fully raised or lowered.

  2. INSPECT REAR CURTAIN SUB-ASSEMBLY RH

    A000YPUE05
    Text in Illustration
    *a

    Component without Harness Connected

    (Rear Curtain Sub-assembly RH)

    1. Apply battery voltage and check the operation of the rear curtain sub-assembly RH.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 2 (SSA+)

      Battery negative (-) → 1 (SSA-)

      		 Rear curtain sub-assembly RH raises

      Battery positive (+) → 1 (SSA-)

      Battery negative (-) → 2 (SSA+)

      		 Rear curtain sub-assembly RH lowers

      CAUTION:

      Be careful when the rear curtain sub-assembly RH raises and lowers. Something could get caught in the rear curtain sub-assembly RH and cause an injury.

      Tech Tips

      To prevent the motor from burning out, stop operation as soon as the rear curtain sub-assembly RH is fully raised or lowered.

  3. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. Remove the integration control and panel assembly Click here.

    2. A000VNAE03
      Text in Illustration
      *a

      Component without Harness Connected

      (Integration Control and Panel Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Switch Condition Specified Condition
      13 - 9 Rear door sunshade switch LH is pushed Below 200 Ω
      Rear door sunshade switch LH is not pushed 10 kΩ or higher
      4 - 9 Rear door sunshade switch RH is pushed Below 200 Ω
      Rear door sunshade switch RH is not pushed 10 kΩ or higher

      If the result is not as specified, replace the integration control and panel assembly.