PROCEDURE
REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)
REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)
REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)
REMOVE BATTERY SERVICE HOLE COVER LH
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.
Note
When disconnecting the cable, some systems need to be initialized after the cable is) reconnected Click here.
REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
REMOVE REAR SEAT ASSEMBLY (for Power Seat)
REMOVE REAR SEAT ASSEMBLY (for 5-Passenger with Ottoman)
REMOVE REAR SEAT ASSEMBLY (for 4-Passenger with Ottoman)
REMOVE REAR DOOR SCUFF PLATE LH (for Standard Body)
REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)
REMOVE REAR DOOR SCUFF PLATE RH (for Standard Body)
REMOVE REAR DOOR SCUFF PLATE RH (for Long Body)
REMOVE REAR SEAT SIDE GARNISH LH
REMOVE REAR SEAT SIDE GARNISH RH
REMOVE INNER ROOF SIDE GARNISH LH
REMOVE INNER ROOF SIDE GARNISH RH
REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
except 4-Passenger with Ottoman:
Using a moulding remover D, detach the 4 claws and remove the 3 belt guides.
for 4-Passenger with Ottoman:
Using a moulding remover D, detach the 4 claws and remove the 2 belt guides.
except 4-Passenger with Ottoman:
Detach the 2 clips of the package tray trim panel assembly. Then pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
for 4-Passenger with Ottoman:
Detach the 2 clips of the package tray trim panel assembly. Then pass the 2 rear seat belt floor anchors through the package tray trim panel assembly.
Disconnect the solar sensor connector and remove the package tray trim panel.
REMOVE NO. 2 ROOF SIDE AIR DUCT LH (w/ Rear Cooler)
REMOVE NO. 2 ROOF SIDE AIR DUCT RH (w/ Rear Cooler)
REMOVE REAR NO. 4 AIR DUCT (w/ Rear Cooler)
REMOVE REAR NO. 5 AIR DUCT (w/ Rear Cooler)
REMOVE STEREO COMPONENT SPEAKER ASSEMBLY
REMOVE NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY
Detach the 5 claws and 3 clips, and remove the No. 2 package tray trim panel assembly.
REMOVE REAR SUNSHADE ASSEMBLY
Remove the 4 bolts.
Loosen the bolt labeled A and remove the rear sunshade assembly.
|
Bolt A |
Note
Do not remove the bolt labeled A from the rear sunshade assembly.