FUEL LID OPENER MOTOR ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FUEL LID MOTOR LOCK ASSEMBLY


    1. A000WG2E01

      Connect the connector.

    2. Install the fuel lid motor lock assembly with the 2 nuts.

      Torque:
      for nut A
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }
      for nut B
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  3. INSTALL REAR FLOOR FINISH PLATE

    Click here

  4. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  5. INSTALL NO. 1 COOLER COVER (w/ Rear Cooler)

    Click here

  6. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  7. INSTALL DECK TRIM SIDE BOARD RH

    Click here

  8. INSTALL ROPE HOOK ASSEMBLY

    Click here

  9. INSTALL ROPE HOOK

    Click here

  10. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

  11. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  12. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  13. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here