TRUNK LID ACTUATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here

  7. REMOVE ROPE HOOK ASSEMBLY

    Click here

  8. REMOVE ROPE HOOK

    Click here

  9. REMOVE DECK TRIM SIDE BOARD RH

    Click here

  10. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  11. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler)

    Click here

  12. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

    Click here

  13. REMOVE REAR FLOOR FINISH PLATE

    Click here

  14. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  15. REMOVE LUGGAGE CLOSER MOTOR ASSEMBLY


    1. A000UQE

      Disconnect the connector.

    2. Remove the 3 bolts and nut.

    3. Remove the luggage closer motor assembly.