REAR DOOR WINDOW FRAME MOULDING(for Standard Body) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The procedures listed below are for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR WINDOW UPPER FRAME MOULDING LH


    1. Attach the clip to install the window frame moulding.

    2. Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.

    3. Using the air riveter or hand riveter, install the 6 rivets shown in the illustration.

      Tech Tips


      • As there are 2 types of rivets, be sure to install the rivets to the correct locations.

        Rivet Rivet Type
        (A) Short Type or Long Type
        (B) Long Type

      • If the rivet cannot be cut, pull it once and cut it.

      A000XRBE08
      *1 Rivet (B)
      *2 Rivet (A)

      Note


      • A000YPVE59
        *1 INCORRECT
        *2 Riveter
        *3 Mandrel
        *4 CORRECT

        Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

      • A000VNRE38
        *1 Riveter
        *2 INCORRECT
        *3 CORRECT

        Confirm that the rivets are seated properly against the moulding.

      • Do not tilt the riveter when installing the rivet to the moulding.

      • Do not leave any space between the rivet head and moulding.

      • A000Z60E35
        *1 Riveter
        *2 INCORRECT
        *3 CORRECT

        Do not leave any space between the moulding and door frame. Firmly hold together the 2 items while installing the rivet.

  2. INSTALL REAR DOOR NO. 2 WEATHERSTRIP LH

    Click here

  3. INSTALL REAR DOOR NO. 3 WEATHERSTRIP LH

    Click here

  4. INSTALL REAR DOOR FRAME GARNISH LH

    Click here

  5. INSTALL REAR DOOR TRIM COVER LH

    Click here

  6. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/o Rear Door Sunshade)

    Click here

  7. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Rear Door Sunshade)

    Click here

  8. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  9. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here