FUEL LID OPENER SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch ON (IG).

    3. Turn the intelligent tester ON.

    4. Enter the following menus: Body / Main Body / Data List.

    5. According to the display on tester, read the "Data List".

      Main Body:
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Fuel Lid Opening Switch Fuel lid opener switch signal/ON or OFF

      ON: Fuel lid opener switch is pushed

      OFF: Fuel lid opener switch is not pushed

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    Note

    When a Body No.4 (luggage room junction block) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch ON (IG).

    3. Turn ON the intelligent tester.

    4. Enter the following menus: Body / Body No.4 / Active Test.

    5. According to the display on tester, perform the "Active Test".

      Body No.4:
      Tester Display Test Part Control Range Diagnostic Note
      Fuel Lid Open Operate fuel lid opener motor assembly OFF / ON -