CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart Click here.
PROCEDURE
INSTALL BENCH TYPE REAR SEATBACK COVER
for LH Side:
Set the bench type rear seatback cover in place.
Using hog ring pliers, install the bench type rear seatback cover to the bench type rear seatback pad with 30 new hog rings.
Note
Be careful not to damage the bench type rear seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.
| *1 | Hog Ring Pliers | - | - |
| *a | Front View | *b | Rear View |
for RH Side:
Set the bench type rear seatback cover in place.
Using hog ring pliers, install the bench type rear seatback cover to the bench type rear seatback pad with 31 new hog rings.
Note
Be careful not to damage the bench type rear seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the bench type rear seatback cover.
| *1 | Hog Ring Pliers | - | - |
| *a | Front View | *b | Rear View |
INSTALL REAR SEAT WIRE RH
INSTALL REAR SEAT CLIMATE CONTROL ECU LH
INSTALL REAR SEAT CLIMATE CONTROL ECU RH
INSTALL REAR SEAT SHOULDER BELT GUIDE LH
INSTALL REAR SEAT SHOULDER BELT GUIDE RH
INSTALL REAR SEAT HEADREST SUPPORT
INSTALL REAR SEAT ARMREST HOLE COVER
INSTALL REAR CENTER SEAT HEADREST ASSEMBLY
INSTALL REAR SEAT HEADREST ASSEMBLY
INSTALL REAR SEAT CENTER ARMREST ASSEMBLY
INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY
INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
CHECK SRS WARNING LIGHT
CHECK REAR SEAT ASSEMBLY