AIR HOSE(for Ottoman) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.

  2. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE DECK BOARD ASSEMBLY (w/o Spare Tire)

    Click here

  4. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire)

    Click here

  5. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  6. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

    Click here

  8. REMOVE REAR SEAT ASSEMBLY

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  10. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE REAR SEAT SIDE GARNISH RH

    Click here

  13. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  14. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  15. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    Click here

  16. REMOVE ROOF SIDE NO. 2 AIR DUCT LH

    Click here

  17. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

    Click here

  18. REMOVE AIR HOSE

    A000XJS

    1. Using a screwdriver, detach the 2 claws and remove the hose clamp.

    2. Disconnect the air hose connector.

    3. A000VEZ

      for LHD:


      1. Remove the 2 hose clamps and bolt.

      2. Detach the 2 claws and remove the air hose.

    4. A000UU3

      for RHD:


      1. Remove the hose clamp and bolt.

      2. Detach the 2 claws and remove the air hose.